1.5″ Adventure Dog Collar Design
The 1.5″ Adventure Dog Collar is an adjustable, waterproof dog collar. This collar is made with stainless steel or solid brass hardware and Chicago screws.
- 1.5″ buckle in choice of roller or collar buckle. If your dog is on the smaller side we would suggest a roller buckle since the collar buckles are quite a bit heavier and larger (4-6 ounces)
- Hardware finish available in stainless steel or solid brass
- Two tone option available (if your dog is on the smaller side we recommend a single color since this option adds more hardware and weight)
- 1.5″ D-Ring
- Chicago screws that are also secured with thread locker
Sizing Guide For The 1.5″ Adventure Dog Collar
Please measure your dog’s neck with a soft tape measure to find the right collar size. The tape measure should be snug, but with enough room to slip a finger or two between the tape measure and your dog’s neck.
Each collar has 3 holes that are one inch apart. Choose the collar size where your dog’s neck size matches the middle hole, and we will put 1″ on either side for comfort. So a 16″ collar will fit 15″-17″ neck sizes.
Check the “growing dog” option if your dog is still growing. We’ll start the first hole at the puppy’s current neck size and add one extra hole. Ex; puppy’s neck is 16″, the puppy collar will be from 16″-19″.
The 1.5″ collar is recommended for neck sizes above 14″.
- Webbing on the inside and heavy-duty, non-tacky PVC coating on the outside
- Cold weather resistant (won’t become brittle until -56° F)
- UV resistant (won’t fade)
- Sensory friendly: won’t hurt your hands like rope leashes or nylon leashes
- Doesn’t tangle or knot easily
- Will not crack or fade
- Doesn’t need to be oiled
Collar Hardware Information
All of our adventure dog collars are available in stainless steel or brass. The screws will match the buckle choice.
Stainless steel *may* eventually rust (but not easily), and brass does not rust but rather develops a patina. Stainless steel and brass are the best options if you plan on using your collar in water, especially saltwater.
To prevent the hardware from oxidizing it’s best to dry your product ASAP, and to especially rinse off any saltwater. In the case that your hardware rusts or patinas, we recommend searching Google for the best methods to remove the discoloration (methods are different depending on which metal you chose).
To clean your collar, take a bucket of water (temperature doesn’t matter), and add some dish soap. Then swish the collar around in the bucket, rinse clean and allow to air dry. For more stubborn areas use a gentle wet cloth and rub with a bit soap and rinse clean.